iCAM7 series

• iCAM activates when user approaches or when card is presented.

• Picture capture range is 11-15 inches (28-38cm) away.

• Self or auto/set height adjustment.

• Placing dot over the bridge of nose, easily helps alignment.

• Orange turns to green when user is at correct distance.

• Visual indication is amplified with friendly audio prompts.

• Right and left irides are acquired.

• A face picture can also be captured.

Recommended Mounting Information

• The recommended mounting height for the iCAM7 series is 138cm (54.3 inches) from the floor to the bottom of the unit. This mounting height can be adjusted to accommodate the height of the average user at the installed location.
• High amounts of ambient light must be avoided. Intense light sources such as sunlight or halogen lamps may reduce the image capture performance of the iCAM which may result in an increased “Failure to acquire” rate.
• The iCAM is not weatherproof and must not be exposed to precipitation or extreme temperatures. A 3rd party enclosure may be used to protect the unit if required. See www.irisid.com – Support & Service for more information.

Mounting & Stand Solutions

The iCAM7 Series unit can be fitted to an optional desktop Stand, recess mount (with optional recess mounting kit), or surface mount (available out-of-the-box).

Surface Mounting

The iCAM can be surface mounted with standard equipment provided with the contents of your unit. Review the following procedure for instruction on how to surface mount your iCAM7 series unit.

1. Open each cap at both sides of unit, and remove the screws to release the front door. (Left : MIC / Screw Cap. Right : USB Connector / Screw Cap)
2. After opening the front door, loosen the screw. Unscrew the installation plate screw to separate from the installation plate.
3. Separate the installation plate by sliding the plate downward.
4. Place the installation plate on the desired wall and screw into wall. Feed any needed wiring through the installation plate hole (i.e.: Power, Ethernet, etc).
5. Slide the iCAM7 series into the installation plate and fasten the installation plate with a screw.
6. Before wiring unit, confirm the power is in the off position. Route and connect the Power and Ethernet wires to iCAM7 series.
7. Turn on Power source and switch the power switch of the iCAM7 Series unit to the ON position.
8. After wiring the unit and switching it to the ON position, close the front door and fasten the screws (with screw caps placed back into closed position).

*Note: If connecting any other wiring such as Wiegand, GPI/O to the iCAM, review the following section “Wire Connection Details” before closing front door and fastening screws.

Recess Mounting (optional)

The Recess mounting kit is most often used with units that will installed into a wall cavity, for the purposes of minimizing the visible profile of an iCAM7 series unit. For information on acquiring an optional Recess Mounting Kit, contact your authorized Iris ID product re-seller for details. Instruction for Recess Mounting Kit installation can be found on the www.irisid.com website.

Desktop Stand (optional)

The Desktop Stand is most often used with units that will be setup as an enrollment station camera unit, or for locations that are best suited for tabletop/Desktop usage of an iCAM7 series unit. For information on acquiring an optional Desktop Stand, contact your authorized Iris ID product re-seller for details. Instruction for Desktop Stand hardware setup can be found on the www.irisid.com website.